marinevilla.blogg.se - Number press software user manual

NUMBER PRESS SOFTWARE USER MANUAL MANUALS
NUMBER PRESS SOFTWARE USER MANUAL INSTALL
NUMBER PRESS SOFTWARE USER MANUAL DRIVER

Windows XP, Vista, 2000 and legacy 16-bit Windows 95/98/ME operating systems are not supported. 512 MB of physical RAM, (2 GB of physical RAM is recommended for USB 3.0 captures)ĭata Center software is compatible with 32-bit and 64-bit versions of Windows 7, and Windows 8/8.1/10.Intel or AMD processor running at a minimum speed of 2.0 GHz.

NUMBER PRESS SOFTWARE USER MANUAL MANUALS

Refer to the manuals of the Beagle analyzer, PD analyzer, Promira platform, or Komodo interface for additional information regarding the overview, driver, and compatibility.

NUMBER PRESS SOFTWARE USER MANUAL DRIVER

Be sure the device driver has been installed before plugging in the Beagle analyzer, PD analyzer, Promira platform, or Komodo interface. The following sections describe the minimum system requirements to run the Data Center software. The captured data or a filtered view can be saved as a csv, binary, or tdc file for future analysis. The captured data can be filtered during or after the capture. The capture can be stopped at any time by clicking the ( "Stop") button.

As traffic is seen on the bus, it will be displayed in real-time in the Transaction window.

There is no need to be alarmed since these events correspond to electrical noise created during the physical connection event.

For USB, connect the target device to the Beagle USB 12/480/5000 analyzer.

Click the ( "Run Capture") button in the toolbar to start the capture.

Ensure the Protocol Lens is set to the appropriate protocol (CAN, I 2C, SPI, eSPI, USB, or USB PD).

Click on the ( "Capture Settings") button in the toolbar.

Set any other device settings as appropriate.

Click on the ( "Device Settings") button in the toolbar and make sure the correct capture protocol is selected in the pull-down list.

Click the ( Connect to Analyzer ) button in the toolbar and connect to an available analyzer, platform, or interface.

The target host port, however, can be connected now.) (For USB, do not attach the target device until the capture been started.

Attach the Beagle analyzer, PD analyzer, Promira platform, or Komodo interface to the bus under test.

Plug in the Beagle analyzer, PD analyzer, Promira platform, or Komodo interface into the analysis computer.

NUMBER PRESS SOFTWARE USER MANUAL INSTALL

Install the Total Phase USB driver and Data Center software.For more detailed information, please refer to the specific sections in this manual. These are the basic steps for capturing data with a Beagle analyzer, PD analyzer, Promira platform, and Komodo interface. If traffic is already present on the bus, the first packet may appear corrupted or incomplete since the Beagle analyzer, PD analyzer, Promira platform, and Komodo interface may start monitoring traffic midway into a transmission. This allows the Beagle Analyzer to capture the descriptor information that is communicated at device connection.įor all other protocols, the capture can be started before or during the presence of traffic on the target bus. When monitoring USB, it is best to attach the Beagle analyzers analysis port and start the capture before the attaching target device port. The general flow for capturing traffic is the same with any Beagle analyzer (whether it be the USB 5000, USB 480, USB 12, or I 2C/SPI analyzer), PD analyzer, Promira platform, or Komodo interface with the following caveats.

8.5 Transaction-Level and Class-Level Parsing.5.4 Connecting to a Beagle Analyzer or Komodo Interface.5.3 Getting Around the Total Phase Data Center Application.

5 Using the Total Phase Data Center Application.